BendixKing KMA 30 - Manual (Page 13)

August 2012 KMA 30 Pilot Guide Page 13
Recorder Playback
The internal recorder is always storing the
audio from the radio selected for transmit.
To play back the last incoming audio,
hold the RCV (top) button on the radio
selected to transmit for one second, and
release. The playback will start. Playback
stops if the radio becomes active, but the
new incoming message will not be re-
corded. When the radio stops, press play
and you will be in the same message you had playing.
To hear an earlier message, hold the COM RCV button until playback
stops again, and then press again to begin playing the next earlier mes-
sage. Repeat until you hear the message you wanted. Incoming new
messages will stop playback, and you can then restart.
A remote playback switch may also be installed.
Note: when you switch from one transmitter to another, the recordings
are lost.
Blinking indicators
This chart shows you what the blinking LEDs mean.
COM 1 or COM 2 XMT Every 1 second Pilot or copilot is transmitting
COM 1 or COM 2 RCV Every 3 seconds Monitor mode activated
ICS mode Every 3 seconds Pilot has music in ISO
Mute and SPR buttons Every 1 second PA Mode active
What is blinking? How often? What it means