CANOGA PERKINS 3240S SNMP-Managed T1/E1 Fiber-Optic Multiplexer - Manual (Page 23)

EdgeAccess
3240S Fiber-Optic Multiplexer 3-3/(3-10 Blank)
User Interface Organization
The user interface consists of selectable, nested screens, available in this order:
The user interface consists of nested screens, selectable by number and available in this order:
Main Menu
1. SNMP Agent Configuration
5. Host and Community Tables
1. Host Table
2. Community Strings Table
6. System Variables Configuration
7. SLIP Configuration
2. Multiplexer Configuration/Status
1. System Configuration/Status
1. Optic Redundancy Control
2. Composite Loopback Menu
2. I/O Port Configuration/Status
3. Set/Clear Port Loopback
3. Trap Configuration
1. System Trap Configuration
2. Port Traps
3. Diagnostics
4. Software Upgrade
5. Modem Setup
Login and Main Menu
The first screen is the Login Menu. If this is your initial setup and no password has been set, press
<Enter> at the prompt for the password. Otherwise, type your password and press <Enter>.
You can reach all configuration options from the Main Menu; see Table 3.
Table 3. Main Menu Selections
Menu Item Description
1. SNMP Agent Configuration View and set values for the communications parameters
2. Multiplexer Configuration/Status View and set values for the system information parameters
3. Diagnostics Run the diagnostic PING
4. Software Update Download and install new firmware
5. Modem Setup View and set values for modem parameters
6. User Interface Password Set password for a connections through the serial port or Telnet