CANOGA PERKINS 3240S SNMP-Managed T1/E1 Fiber-Optic Multiplexer - Manual (Page 27)

EdgeAccess
3240S Fiber-Optic Multiplexer 3-7/(3-10 Blank)
4. To delete a host, type 2 and press <Enter>, then at the prompt, type the IP Address for that Host
and press <Enter>. The host table appears again with your changes.
5. To return to the Host and Community Tables menu, press <Esc>.
6. To update the read and wrote community strings, type 2, "Alias Community String Table," and
press <Enter>. The Community Strings Table appears.
• To enter the Read string, type 1 and follow the prompts on the screen.
• To enter the Write string, type 2 and follow the prompts on the screen.
7. To return to the Main Menu, press <Esc>.
Change Your Password
You can update your password for the 2346 in order to maintain security. You cannot change the
password for any other users, especially those who are not logged in. To update your password,
follow these steps:
1. From the Main menu, type 6 , "User Interface Password," and press <Enter>.
2. To change your password, follow the prompts on the screen.
3. To return to the Main Menu, press <Esc>.
Manage the Multiplexer
Many of the multiplexer functions are controlled by hardware jumpers and switches on the main
board, interface boards, or front and rear panels. You can monitor the multiplexer functions and the
data transmission or set up redundancy options.
Check Status
To check system status, including information about the power, copper, and fiber configuration and
status, follow these steps:
1. From the Main menu, type 2 , "Multiplexer Configuration/Status," and press <Enter>.
2. At the Multiplexer Configuration/Status menu, type 1 , "System Configuration Status."
3. To return to the Main Menu, press <Esc>.