CANOGA PERKINS 3240S SNMP-Managed T1/E1 Fiber-Optic Multiplexer - Manual (Page 9)

EdgeAccess
3240S Fiber-Optic Multiplexer 1-1
Chapter 1
Overview
3240S Fiber Optic Multiplexer
The 3240S Fiber Optic Multiplexer supports and manages T1 and E1 channels over single mode and
multimode optical links. The 3240S chassis accommodates up to eight T1 channels on up to two I/O
cards or up to six E1 channels on up to two I/O cards. The bandwidth is divided into four time slots
and the chassis provides two physical slots. Each I/O card occupies one physical slot and requires
two time slots.
Options for the 3240S include AC or DC power, redundancy for both power and optics, and
1300/1550 nm single mode and 850/1300 nm multimode fiber optics.
Figure 1 shows the front of the 3240S with the SNMP Management module. Figure 2 shows the rear
of the 3240S with T1X and E1X cards.
Figure 1. 3240S Front Panel
Figure 2. 3240S Rear Panel
The 3240S can be set up as a managed system, controlled through the Management software with
certain hardware settings or as a non-managed system, controlled through the hardware switches and
jumpers. For details on a non-managed system, see Chapter 2; for a managed system, see Chapter 3.
For best results, use either the hardware control or the software management, but not both.