CANOGA PERKINS 3240S SNMP-Managed T1/E1 Fiber-Optic Multiplexer - Manual (Page 29)

EdgeAccess
3240S Fiber-Optic Multiplexer 3-9/(3-10 Blank)
4. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
5. To return to the Main Menu, press <Esc>.
Table 5. System Trap Configuration Options
Type of Trap When enabled, sends a Trap if. . .
2) Composite Sync Loss Received optical signal fails
3) Link Switch The link switches between primary and secondary (backup)
4) Fault Relay State A fault (alarm) occurs
5) System Loopback System loopback is enabled or disabled
6) Configuration Error The same physical slots in two units hold mismatched types of I/O
cards or the time slot jumpers are mismatched; see page 2-1
7) Card Insert/Remove An I/O card is inserted or removed
8) Backup Link OK/Bad The backup link changes between good and failed
9) Cold Start/Authentication The 3240S is reset by a power-up or SNMP reset or an unauthorized
host attempts SNMP access with an incorrect community string
10) Power Supply/Malfunction One of dual power supplies fails
Table 6. I/O Port Trap Output Options
Type of Trap When enabled, sends a trap if. . .
1) Per Port Loss of Sync or Alarm Indication Signal (AIS) occurs; also functions as master
enable/disable traps for each port
2) Port Loopback Port loopback is enabled or disabled
3) Port A Trap occurs on the selected I/O port