CANOGA PERKINS 2361 T1 Modem - Manual (Page 67)

The EdgeAccess Universal Chassis System
2361 Modem Users Manual 8-3
8.3 Installing the New Software
Instructions for installing software into the rackmount modem (in a UCS Chassis) via DMM will
differ from installing into a standalone modem.
8.3.1 Installing in a Managed UCS Chassis
For these instructions, please refer to the DMM users manual.
8.3.2 Installing into a Standalone Modem Via TFTP
This installation is performed over the dial-up network and requires that the standalone modem
has the SNMP option. If this option is not activated, contact Canoga Perkins to activate it.
To upgrade and install the new software version, perform the following: (The following steps
assume that the TCP/IP stack has been activated for this modem.)
Figure 47. To Download a Software Revision, Type "3" From the Software Upgrade Screen
1. From the Main Menu type "6" and press Enter.
2. Use the TFTP feature here to download the software to the inactive flash region of the
modem.
3. Make sure the new firmware file is in the root directory of your TFTP server (The TFTP
server must be running).
4. Type "3." The TFTP Operation Screen appears.
5. Enter the TFTP Server IP Address.
• Use the default IP address, or
• Follow the on-screen prompts for saving the IP Address as the default.
6. Enter the filename, for example,
2X6X0173.zip
. for firmware