CANOGA PERKINS CanogaView Smart Element Manager - Manual (Page 13)

CanogaView ® Smart Element Manager
Enterprise Version 7
Chapter 2
Installing CanogaView Smart Element Manager
All files necessary for the installation of the CanogaView Smart Element Manager software
are contained on the installation CD. Additionally, this manual as well as other technical
information is also contained on the CD and installed with the software.
2.1 Installation Process
The following steps assume that the CanogaView Smart Element Manager software is being
installed via the installation CD. If the software has been downloaded from Canoga Perkin’s
corporate web site, then locate the “install.htm” file at the top of the downloaded directory
tree and select/execute it.
If you install CanogaView onto a computer running Network Node Manager (NNM) and you
select the option to integrate with NNM, the NNM services must be running. Additionally, if
the NNM user interface is running, ensure that the Event Configuration application is not
displayed. You will be reminded of this during the installation.
Note: The actual install process will vary slightly depending upon the hardware
platform, operating system software and the response to installer prompts. Not all of
the installer steps described appear during installation. The installation screen
examples shown in this manual are from a Windows NT installation with HP
OpenView NNM also installed.
2.2 Installation Steps
2.2.1 Insert CD
Windows Platforms
Insert the CD into the CD-ROM drive.
If the installer web page did not automatically display when the CD was inserted into
the CD-ROM drive, locate the file install.htm and double click on it or open it with
your browser (File >> Open or File >> Open Page). Read the installation
instructions and then proceed to the next step.
The next step in the installation process is basically to locate and execute the
installation procedure which is on the CD. This can be done by selecting (clicking) on
this install link, or by locating the InstData/Windows/Vm directory on the CD ROM
and executing the file install.exe.
Next proceed to section 2.2.2.