CANOGA PERKINS CanogaView Smart Element Manager - Manual (Page 8)

CanogaView ® Smart Element Manager
2 Standalone Version
device that is to be managed. Additionally, if trap/alarm monitoring is desired, then the
appropriate “access level” and “trap port” must be setup.
The SNMP Agents currently supported are:
• Domain Management Module (DMM) for management support of the Universal
Chassis System (up to eight 2U and 5U chassis per DMM) and its components.
• 9135 Two Port EdgeAccess™ Switch - 100BASE-TX/FX Compliant Fast Ethernet
device with the SNMP Management Module.
• 9140 Four Port EdgeAccess™ Switch - 100BASE-TX/FX Compliant Fast Ethernet
device with the SNMP Management Module.
• 9135G Gigabit Two-port EdgeAccess™ Switch is a 1000BASE-LX compliant
Ethernet device with SNMP Management Module.
It is important that the software (aka firmware) installed on any of the SNMP Agents listed
above, be at the required level in order for CanogaView Smart Element Manager to correctly
access the essential management data residing at the network element level.
An example telnet session screen showing the DMM Host Table is shown below:
Figure 1-1: DMM Host Table