CANOGA PERKINS 9155 Network Interface Device - Manual (Page 24)

To view the current addresses, follow these steps:
1. From the IP Settings screen, type 7 , "Dynamic ARP Table," and press <Enter>.
2. To return to the IP Settings screen, press <Esc>.
4.5.4 Host Access Table Screen
The SNMP agent allows access to up to 24 Host IP addresses. Set up and edit the Host information
for the 9155 at the Host Access Table screen. See Figure 12. To access the Host Access Table,
follow these steps:
1. From the System menu type 3 , "Host Table/ SNMP Settings," and press <Enter>.
2. At the Host Access Table screen, type 1 to edit a host at the Edit Host Access Entry screen, 2 to
add a host at the Add Host Access Entry screen, or 3 to remove a host, then follow the prompts.
3. To return to the System Menu, press <Esc>.
HOST ACCESS TABLE
Managing Host Telnet FTP/ SNMP SNMP V1/V2c Rd V1/V2c Wr V1/V2c
IP Address/Mask Access TFTP Access Protocol Community Community Access Lvl
172.016.002.232/32 Yes FTP Write V1/V2c/V3 public netman Supervisor
172.002.002.232/32 Yes FTP None V1/V2c/V3 public netman Observer
172.016.142.001/32 Yes Both Write V1/V2c/V3 public netman Observer
1. View/Change Host
2. Create Host
3. Delete Host
4. Main Menu
Figure 12. Host Access Table Screen
4.5.5 Notification Destination Table Screen
The Notification Destination Table screen lists information about and options to set up hosts to
receive notification of traps and alarms. To access the Notification Destination Table screen, see
Figure 13 and follow these steps:
1. From the System menu type 4 , "Notification Settings," and press <Enter>.
2. At the Notification Destination Table screen, type 1 to edit a host or 2 to add a host at the Edit
Notification Destination Entry screen, or type 3 to remove a host.
Note: To add or edit a host entry, follow the prompts on the notification destination entry screen.
3. To return to the System Menu, press <Esc>.
9155 Network Interface Device 4-8