CANOGA PERKINS 9155 Network Interface Device - Manual (Page 40)

Table 12. Latency/Jitter Test Definitions
Parameter Description
1. Test IP Address Where the 9155 sends the packets
2. Test Duration How long to run the test, in minutes and seconds; 0 means don't stop
3. Test Packets per second How many packets to send each second
4/5. Min/Max Test Packet Size Set the size limits for each packet, from 40 to 1472 bytes
6. Test Packet Timeout How long to wait for a test packet to return
4.9.2 PING
Use the PING Generation screen to test the connection to a specific IP address. See Figure 40. To
use PING to check a connection, follow these steps:
1. From the Main Menu, type 5 , "Diagnostics," and press <Enter>.
2. At the PING menu prompt, set the PING parameters, and press <Enter>.
"PING response received..." indicates a good connection;
"TIMEOUT: Unable to reach [IP address]..." indicates a faulty connection.
3. To stop the PING , press <Esc>.
PING
1. Ping Address : 0.0.0.0
2. Ping Count : 0
3. Ping Size : 0
4. Start Pinging
5. Main Menu
Figure 40. PING Generation Screen
9155 Network Interface Device 4-24