CANOGA PERKINS 9171 Configuration Guide - Manual (Page 186)

CanogaOS Configuration Guide
29-3
Command Description
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#transport-address 11.11.4.4 Configure the transport address for a
label space.
DUT1(config-router)#targeted-peer 11.11.1.1 Configure Targeted Peer.
DUT1(config-router)#targeted-peer 11.11.3.3 Configure Targeted Peer.
DUT1(config)#exit Exit the router-ldp mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)#network 11.11.1.1/16 Associate networks with the RIP
process.
DUT1(config-router)# exit Exit the router-rip mode
DUT1(config)# mpls vpls-vlan 4000 4010 Create a block of continuous vlan id
which used for vpls function.
DUT1(config)#mpls vpls v4 100 Create a VPLS instance and come
into the VPLS instance mode.
DUT1(config-vpls)#vpls-peer 11.11.1.1 raw Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer 11.11.3.3 raw Add a PE for VPLS instance.
DUT1(config-vpls)#exit Exit VPLS instance mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode
• eth-0-1—Specify the interface
DUT1(config-if)#mpls-vpls v4 Bind an interface to a VPLS
instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode
• eth-0-1—Specify the interface
DUT1(config-if)#switchport mode trunk Configure trunk mode on the port.
DUT1(config-if)#mpls-vpls v4 vlan 2 Bind an interface to a VPLS
instance.
DUT1(config-if)# mpls-vpls v4 vlan 3 Bind an interface to a VPLS
instance.
DUT1(config-if)# mpls-vpls v4 vlan 4 Bind an interface to a VPLS
instance.
DUT1(config-if)# mpls-vpls v4 vlan 5 Bind an interface to a VPLS
instance.
DUT1(config-if)#exit Exit the Interface mode.
29.2.3 Configuring the VPLS on PE3
Command Description