4 configuring packets per second storm control – CANOGA PERKINS 9171 Configuration Guide User Manual
Page 236
CanogaOS Configuration Guide
35-2
35.4 Configuring Packets per second Storm control
35.4.1 Topology
Figure 35-2: PPS Storm Control
35.4.2 Configurations
Bridge 1
DUT#configure terminal
Enter the Configure mode.
DUT(config)#interface eth-0-1
Enter the interface mode.
DUT(config-if)#storm-control unicast pps 1000
Set unicast pps to 10 packets per seconds.
DUT(config-if)#storm-control multicast pps 100
Set multicast pps to 100 packets per seconds.
DUT(config-if)#storm-control broadcast pps 1000
Set broadcast pps to 1000 packets per seconds.
DUT(config)#end
Exit to exec mode.
DUT#show storm-control eth-0-1
Display storm control information.
35.4.3 Validation
Commands
Bridge 1
DUT#show storm-control eth-0-1
Port ucastMode ucastLevel bcastMode bcastLevel mcastMode mcastLevel
eth-0-1 PPS 10 PPS 1000 PPS 100