CANOGA PERKINS 9171 Configuration Guide - Manual (Page 62)

CanogaOS Configuration Guide
9-16
DUT(config) # erps 1 Create erps domain with id 1.
DUT(config) # erps 2 ring 1 mode transit Set node as transit of ring 1 for domain 2.
DUT(config) # erps 2 ring 1primary interface eth-0-13 Set primary interface of ring 1 for domain 2.
DUT(config)# erps 2 ring 1 secondary interface eth-0-20 Set secondary interface of ring 1 for domain 2.
DUT(config) # erps 2 ring 1 enable Enable ring 1 for domain 2.
DUT(config) # erps 2 enable Enable domain 2.
Switch 3
Create VLANs for transferring ERPS control packets
DUT# configure terminal Enter the configure mode.
DUT(config) # vlan database Enter VLAN database mode.
DUT(config-vlan) # vlan 11,12 Creat vlan 11, 12.
DUT(config-vlan) # exit Exit the vlan mode and enter the Configure mode.
Configure interface eth-0-9
DUT(config) # interface eth-0-9 Enter the Interface mode.
DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add 12 Enable VLAN 12 on this port.
DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.
Configure interface eth-0-20
DUT(config) # interface eth-0-20 Enter the Interface mode.
DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add
11,12 Enable VLAN 11, 12 on this port.
DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.
Configure interface eth-0-13
DUT(config) # interface eth-0-13 Enter the Interface mode.
DUT(config-if)#switchport mode trunk Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add 11 Enable VLAN 12 on this port.
DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.
Configure and enable ERPS domain
DUT(config) # erps 1 Create erps domain with id 1.