Daiwa SEABORG-1000MT - Manual (Page 21)

19
Surface depth setting
When the main line is cut or broken off.....
Attention
1. When new line is wound up, or when line has been pulled under heavy tension, line
stretch may cause a gap in the depth reading at the surface. Simply reset the surface
setting with the
RESET BUTTON .
2
- Should your line break, revise data as follows.
- For 10m or longer line, the
RESET BUTTON must be pressed
and held for 2 seconds, or must be quickly pressed 3 times
within 2 seconds, to prevent accidental resetting.
Functional setting operation
(3. Before you begin fishing)
3
Before you begin fishing, make sure the counter is set to zero at the waterʼs surface.
This is extremely important to ensure accurate fishing depth readings.
3. Lower the terminal rig to the waterʼs surface and press the
RESET BUTTON . (water surface zero setting)
The display resets to 0.0 and blinks.
1. Connect the reel to the battery, put the line through all the
guides, and prepare your terminal rig.
2. Place the rod into the rod holder in the position it will normally
rest while fishing.