Daiwa SEABORG-1000MT - Manual (Page 35)

33
Functional setting operation
(13. How to fix the Rod Clamp)
1
2
Bolt
Nut
Nut
Collars
Washer
Wrench
Tighten
Rod Clamp
rod
1.
Insert the Bolt in the clamp setting hole, and fix it by tightening
the Nut and the Washer.
2 . Hold the rod in position while attaching the clamp.
Tighten the rod clamp nuts to secure.
Use collars only for rods with 25mm or
smaller blank/reel seat diameter.
Attention
- If the Nut is tightened too firmly, there is a danger of deforming the rod depending upon
rod material, especially with composite rods and reel seats.
When using a metal rod butt or fishing for large, hard-pulling fish, always secure the reel with a Rod
Clamp.
(Using the Rod Clamp, it is possible to clamp rods with diameters of 23-34mm)