Leica Geosystems Leica DISTO Classic5 - Manual (Page 6)

6 How to Use the Instrument DISTO classic 5 1.2.0 en
de
en
fr
it
es
pt
nl
da
sv
no
fi
jp
zh
ko
pl
hr
hu
ru
cz
el
Menu/ Settings
With this menu settings on the user level are possible. The
user can configure the instrument to his/her own specific
and personal needs.
D5-Z9
1 Measure with offset (add/reduce)
2 Selecting measuring units
3 Beep
4 Reset
Calling up a menu:
Press until desired menu point appears or with
key [+ / -] switch between the various menu
points.
Confirm selection, activate menu point.
or with key [+ / -] change setting as desired.
Confirm selection, reset to Normal Mode.
)
"Clear Entry" may also be used (e.g. to cancel a
selection).
Selecting units
Selectable units:
Measure with offset
D5-Z10
Call up menu point.
blinks on the display.
With key [+ / -] set desired offset (=shifting reference) (e.g.
0,015m); quick set by keeping key pressed.
For larger steps hold additionally.
)
Offset can be positive (add) or negative
(reduce)!
Confirm setting.
Is displayed continuously if offset
≠
0.
)
Subject to set offset, the measured results are
displayed.
Using this function you can measure with rough size, as an
example!
Please make this a rule: After rough size measurement
always set the DISTO to offset 0.000: Call up function as
described
Press.
Confirm function.
– m (mm) = 0.000 m – 14’ 06’’ 1/16 = ’ ’’ 1 /
16
– m (cm) = 0.00 m – in = 0.0 in
– ft = 0.00 ft – in 1/16 = 0 1 /
16
in
– ft in 1/16 = 0.00 1 /
16
ft in