Leica Geosystems PlusDraw - Manual (Page 12)

9
Wall Height Input Dialog
Tapping on the toolbar will open the wall height input dialog (
Image 16 ). From within this
dialog, specify the wall height for the current area. This value will be used to calculate the cubic
volume and the wall surface area.
Once the dialog opens, measure the wall height using the DISTO and press the Enter key using
the 2
nd function layer on the DISTO device. The measured value will be entered for the wall
height, and the dialog window will close.
Note: If the PlusDraw keyboard is used to input the wall height, tap OK to close the dialog
window.
Page Management Dialog
Use pages to organize multiple rooms or areas in a single sketch file. Each sketch file can
contain a virtually infinite number of pages, depending on the PPC’s available resources.
Tapping on the toolbar will open the page management dialog (
Image 17 ). From within this
dialog, pages can be added, deleted, inserted, or sorted.
Adds a blank page to the current sketch file. The page is
added to the end of the list.
Deletes the se lected page from the sketch file.
Allows a sketch page to be inserted. The page will be
inserted before (above) the highlighted page.
Allows the pages to be sorted based on the direction
selected.
DISTO measurement will
be automatically entered.
Image 16
Image 17