Leica Geosystems PlusDraw - Manual (Page 13)

10
This version of PlusDraw allows one area to be drawn per page, and the data shown on each of
the View Tabs (tabs A, B, and C -
Image 12 ) relates to the selected page.
To properly select a page, tap the desired page and then tap OK. The Drawing View (Tab A) will
open to display the sketch for the selected page. Tabs B and C will display information for that
specific sketch.
Image 18 shows the relationship of a single sketch file (named Sketch 1 ) and its pages:
Drawing Using the DISTO*
Note: PlusDraw will receive distance measurements in units (meters by default) set on the
DISTO device. The unit of measure should not be changed during sketching. Refer to the
DISTO manual for information on setting the unit of measure prior to connecting to PlusDraw.
To properly draw and calculate an Area using both PlusDraw and the DISTO device, you must
first establish a connection between the PPC and the DISTO as described in the previous
sections.
Image 18
Kitchen
(page 1)
Bedroom 1
(page 2)
Bedroom 2
(page 3)
Sketch 1
Tab A Tab B
The page names are generated from the
data in field 3 of tab B. If this field is left
blank, the pages will be numbered
numerically (e.g. 1, 2, 3, etc.)