Panasonic WV-CM143 - Manual (Page 11)

SETUP OPERATION Editing Set Up menu
Before entering the Set Up menu, remember the ALL
RESET operation in order to escape from the confusion as
follows.
(1) Confirm that the Mode Selection Switch is set to the
ON position, the Input Selection Switch is set to the
CAMERA position and Set Up menu is not displayed.
(2) Turn off the power of this monitor.
(3) Turn on the power of this monitor while pressing the
Set Up Switch and Right Switch simultaneously.
All adjustments and selections are reset to the factory
setup condition.
• Entering Setup Menu
r
•• SET UP MENU **
CAMERA ID 12 3 4
1 CAMERA
AUDIO SELECT SEQ
TIMING SELECT INT
SEQ TIME ADJ 1 SEC
ALARM BUZZER ON
ALARM TIME ADJ 60 SEC
AUTO RESET ON
BRIGHT COMP 12 3 4
ElID SET UP DISABLE
Blinking
Press the Camera Selection Switches which is con­
nected with the camera.
By pressing the Set Up Switch for more 2 seconds, the
“SET UP” menu is displayed on the monitor screen as
shown below.
By observing this menu, you can check the present
condition.
Refer to the following sections for details of each item.
After confirming the present condition and further
resetting of each item is not required, move the cursor
to the “END” position on the left bottom line and press
the Set Up Switch to return to the normal camera pic­
ture mode.
Important notice
When the “SET UP DISABLE” is displayed on the
bottom line of the Set up menu, you can not enter
the actual mode setting. This prevents mis-opera-
tion of the mode setting.
f
>
** SET UP MENU *
*
CAMERA ID 12 3 4
1 CAMERA
AUDIO SELECT SEQ
TIMING SELECT INT
SEQ TIME ADJ 1 SEC
ALARM BUZZER ON
ALARM TIME ADJ 60 SEC
AUTO RESET ON
BRIGHT COMP 1 . . 4
END -► SET UP DISABLE:
)
Mr
Press the Set Up Switch.
r >
** SET UP MENU * *
CAMERA ID 12 3 4
1 CAMERA
AUDIO SELECT SEQ
TIMING SELECT INT
SEQ TIME ADJ 1 SEC
ALARM BUZZER ON
ALARM TIME ADJ 60 SEC
AUTO RESET ON
BRIGHT COMP 1 . . 4
END SET UP ENABLE
^
)
To enable the set up menu editing (resetting / readjust­
ment), move the cursor to the bottom line by using the
Up Switch and Down Switch and move to the “SET UP
DISABLE” position by using the Right Switch or Left
Switch and press the Set Up Switch. “SET UP
ENABLE” is displayed.
Move the cursor to the desired item to be reset for
readjust through the “END” position.
Important Notice:
When the cursor is moved to the next position
(next item) after changing the data (ex. ON - OFF),
the latest data is written on the memory (Electronic
Erasable) and Programmable Read Only Memory
(EEPROM) and it remains until the further data
write is made even if the camera power is
switched off.
-9-