Panasonic SC-CH64M - Manual (Page 32)

Using the play timer
4
0REC/
®PUY
POWER
STAHDBV
Select the desired source and
then prepare the stereo for
play.
When you play CD(s):
Press CD and insert CD(s).
Stop the CD(s) after playing.
When you play a tape:
Press TAPE and insert a tape.
Stop the tape deck after you select the
direction of the tape.
When you play the radio:
Press TUNER BAND and tune in the de­
sired station.
When you play a unit connected to the
“AUX" terminals:
Press AUX.
Set the playback volume.
Press © REC/0 PLAY.
Your selections and setting will be stored
in the timer’s memory,
Confirm "© PLAY" lights on the display.
Press POWER to put your ste­
reo on standby.
The timer play will start at the preset time
with volume increasing gradually up to
the volume level you preset.
To switch the timer OFF:
Press © REG/® PLAY and check “0 PLAY" goes out.
The settings made with the preceding procedure will however be kept
in memory.
To check settings (only while power is ON);
Press CLOCK/TIMER 3 times and check "© PLAY" is displayed.
Two seconds later, the display will change in the following order.
© Play start time
(2) Play over time
@ Play source and playback volume
To change settings (only while power is ON);
© Press © REC/® PLAY and check “© PLAY" goes out.
© Reprogram from step 1.
Using the timer at the same time setting continu­
ously;
(You can accomplish this even if your stereo is on standby.)
Press © REC/© PLAY and check “® PLAY" is displayed.
As long as “® PLAY" is displayed, the timer will work every morning
at the same time.
To enjoy the desired source after the timer setting
is completed:
1. After finishing step 6, start playing the desired source.
Even if you change the volume level or music source, the timer
play will start with the preset condition.
^503
When you set the CD changer for timer playback, playback will
start with the last disc played and in the last playback mode used.
2. Press POWER to standby mode after enjoying the play, and
confirm CD(s) or a tape has (have) been inserted.
• If the power is on, the timer will not function. The system must be in
the standby mode.
•The ON time and OFF time cannot be the same setting.
• If you switch the power to the standby mode while the play timer is
functioning, the OFF time setting will not be activated.
• Play timer cannot be used in combination with the record timer.
•The lowest possible volume with the timer is -60 dB. If you set it
lower than this, it will automatically be played back at -60 dB just
the same.
For your reference
External sources must be connected to the “AUX” terminal. However,
time settings apply only to this stereo. For more information, see the
instruction manual of the connected unit.
32