Panasonic SC-CH64M - Manual (Page 9)

-V.BASS
-DEMO
CD
34
•The builtnn demo function will run automatically shortly after
you plug in the system (see page 26).
•The demo function in the power standby mode will be can­
celled automatically by setting the time.
This is a 24-hour display clock.
This example in the figure shows how to set the time for 18:25
(6:25 p.m.).
POWER
Switch on the power.
STANDBY
CLOCK/
TIMER
0 Press CLOCK/TIMER once
to show “CLOCK”.
o.Go:-
Within 7 seconds:
C 2) Press MEWlORY/SET.
0
C L O C h
0 Press V or A to select the
\/TUNtNG/TIME ADJUST/N hOUr
b
J J ^
"-Í M D
r L 0 C f;
©Press MEMORY/SET.
Í £io g ;
C {. D C f;
4
VTUMING/TIME ADJUST^
0 Press V or A to select the
minutes. b
C L D C ¡ - !
© Press MEMORY/SET to fin­
ish setting the time.
The clock now starts.
The display will return to the previous
display after about 5 seconds.
When “0:00” flashes or the demo function is run­
ning:
This happens when you connect the AC mains lead for the first time
or if there has been a power failure.
In this case, reset the time.
If the minutes setting has gone wrong:
1. Press CLOCKATIMER.
2. Press MEMORY/SET twice.
3. Press V or A to set the minutes, and then press MEMORY/SET.
To display the clock again;
Press CLOCKn'lMER.
The display will return to the previous display after about 7 seconds.
For your reference
The hour indication will not change when the minutes pass from “59”
to “00".
Demo function while the power is on;
When the input source is set to “CD" or ‘TAPE", the demo
function wilt run automatically after about 2 minutes or more
in the stop mode.
You can cancel the demo function by pressing and holding
-V.BASS/-DEMO for about 2 seconds or more.