Before requesting help – Panasonic KX-F1000NZ User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before requesting help
General
’■
5
J
........
VK .......
'
1 cannot make and receive calls.
•The power cord or telephone line cord is not connected. Confirm the
connection (see page 7).
1 cannot make calls.
•The setting of the dialing mode is wrong. Check the selector (see
page 7).
The unit does not work.
•Disconnect the unit from the telephone line and connect to a known
working phone. If the known working phone operates properly, call
your service personnel to have the unit repaired. If the known working
phone does not operate properly, consult your telephone company.
The unit does not ring.
•The ringer volume is set to OFF. Raise it to a suitable level (see page
12).
The REDIAL/PAUSE button does
not function properly.
•If this button is pressed during dialing, a pause will be inserted. If this
button is pressed immediately after the dial tone is obtained, the last
number dialed will be redialed.
While programming, 1 cannot
enter the activation code or the
prohibitor ID.
•The whole or part of the number is same as the other code or ID.
Change the number (see pages 22, 32 and 33).
Fax Transmission & Reception
-;■■■■* Ч * / I ■'.,"'ii i
.
■■■"'■■ .
! ■■
;
, . ,
. ■ ■ ■ • .
The other party complains that
letters on their received document
are distorted.
•If your line has special telephone services such as call waiting, the
service may have been activated during the fax transmission. Connect
the unit to a line that does not have such services.
•Another telephone connected to the same line is off the hook. Hang
up and try again.
The other party complains that a
dirty pattern or a black line appears
on their received documents.
•The glass or rollers are dirty. Clean them (see page 53).
I cannot make an international fax
call.
•Use the overseas transmission mode (see page 35).
•Add two pauses at the end of the phone number (see page 42).
I cannot receive documents
automatically.
•The receive mode is set to TEL. Set the receive mode to TEL/FAX or
FAX (or EXT. TAM).
•The time to answer the call may be too long. Decrease the number of
rings (see pages 19 and 20).
•The junk mail prohibitor is set to ON (see page 33).