Panasonic PanaSync S110 - Manual (Page 11)

Installation
^Connecting Procedures
Turn off your computer.
Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS/2 or compatible models
Rear view
AC power cord 15-pin mini
D-Sub cable
monitor's port.
CD Connect the other end of this cable to
a power outlet.
B. Apple computer
© Use a UNIMAC-82D MAC adapter.
Panasonic MAC adapter
If you need an adapter and one is not provided
by your dealer, call 1 -800 PANASYS (1 -800-
726-2797).
r—Caution:-----------------------------------
To prevent the cable from coming loose,
the cable connectors must be securely
fastened with screws.
C. BNC connector signal computer
Rear view
Blue video signal
Horizontal sync
signal or composite
sync signal
Green video
signal or sync
on green
Red video—
signal
© Connect the BNC singnat cable (Not supplied) to the monitor's port.
@ Connect the other end of this cable to a power outlet.
^Connection of AC Power Suppiy
If the AC power supply voltage is in the range 100 to 240V, either 50Hz or 60Hz frequency can be
used.
There is no AC100V/240V selector switch as selection is automatic.
Precaution:
• In order to use the display unit safely, use a power cable that is properly grounded.
• AC plug cords for the following countries are supplied in the same package.
U.S.A....... UL
Canada ....CSA
^ For use in other countries, make sure the AC cord meets the safety standards of each country.
—
5
—