Panasonic KX-TG2650N - Manual (Page 60)

Before Requesting Help
Problem Remedy
“No link to base.
Place on cradle and
try again.
” is displayed
and an alarm tone sounds.
•You are too far from the base unit. Move
closer and try again.
•Insert the handset in the cradle and try
again.
•Plug in the AC adaptor.
•Extend the handset antenna fully.
•Raise the base unit antennas.
The unit does not work. •Check the settings (p. 10-14).
•Charge the battery fully (p. 11).
•Clean the charge contacts and charge
again (p. 12).
•Install the battery properly (p. 58).
•Insert the handset in the cradle and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery and insert the
handset in the cradle {p. 58). Try again.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
•Locate the handset and the base unit
away from other electrical appliances
(P- 3).
•Move closer to the base unit.
•Extend the handset antenna fully.
•Raise the base unit antennas.
•Press iFUNCTiON/CHt to select a clearer
channel.
The handset and/or the base
unit do not ring.
•The ringer volume is set to OFF, Set to
HIGH or LOW (p. 17).
The handset display is
blank.
•The handset is in the standby mode
(p. 9). Press ®, ®, @ or ® to turn
the display on.
The handset display is still
blank after pressing ®,
@ or ®.
________________________ 1
•Charge the battery fully (p. 11).
60