Panasonic CF-28 - Manual (Page 10)

First-time Operation
Power Indicator @
Connect your computer to a power outlet
(miguDsca)
Be sure the AC adaptor is connected until completing Step 8 on page 11,
When closing the cover, first insert the top of the cover.
Handling the AC adaptor
• Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
• Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer.
• When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
• Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
Open the display
(T) Pull the carrying handle forward.
@ Lift up the latch.
@ Lift open the display.
X note >
When using the computer for the first time, do not connect any peripheral device
e.xcept the battery pack and AC adaptor to the computer.
Turn your computer on
Rotate the power switch clockwise and hold it for appro.ximately one second until the
power indicator turns on before releasing it.
. (m!i)ijggC8)
• Do not rotate the power switch repeatedly.
• Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
X note >
The power saving function is factory set, so if there is no input from a key, the
touch pad, the touchscreen {only for models with touchscreen) or an e.xtemal mouse
(when one is connected) for a certain interv'al of time, the power to the LCD and
hard disk may be turned off. The LCD will resume operation when the touch pad,
the touchscreen (only for models with touchscreen) or an external mouse (when
one is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable that
a selection dialog box will be shown, do not press C^aceJ or ( Enter ) to attempt
to resume from this condition as doing so may trigger a selection, but instead, press a
key unrelated to the direct triggering of a selection, like (Ctrl ).
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode
“Standby/Hibemation Functions”). The computer
will resume by rotating the power switch.
10