Panasonic CF-28 - Manual (Page 13)

— Create BACKUP Disks for Reinstallation —
When [You do not need to make “BACKUP DISK”] is displayed (procedure @ below),
there is no need to create a BACKUP DISK. If this message is not displayed, create
backup disks for reinstallation. To create backup disks, the floppy disk drive and format­
ted 2HD floppy disks are needed.
(Ï) Make sure a disk is not in the write-protected state and set it.
iWjnScws^WOl
Select [Start] - [Programs] - [Panasonic] - [Cre­
ate Backup Disk] and follow the on-screen in­
structions.
Select [Start] - [All Programs] - [Panasonic] -
[Create Backup Disk] and follow the on-screen
instructions.
Place a label identifying the contents on each
disk.
Insert the shutter-side
headfirst.
• Names of created BACKUP DISK
FIRSTAID FD (When the display for creating the UPDATE FD is shown, create the
disk by following the on-screen instructions.)
(iaaMts«))
Store the floppy disks in a safe place. They will enable you to return your com­
puter to factory default settings should any problems occur.
When creating backup disks and the message [Insufficient files to copy] is dis­
played, select [OK] and then contact Panasonic Technical Support.
While the MP indicator (^) is on, do not remove the floppy disk, power down
your computer or enter either the standby or hibernation mode ( q = “Standby/
Hibernation Functions”).
When creating backup disks, do not run any other application program.
Be sure to create the backup disk.
If a backup disk is not created, it will be impossible to return the computer to its
original state. In this case, contact Panasonic Technical Support.
13