Panasonic WJ-MX50 - Manual (Page 22)

(2) А-bus :
(3) В-bus
(4) В-bus
Operate the Mix/Wipe Lever (99) from A-bus to B-bus,
or vice versa to the desired display ratio.
The Mix/Wipe LED’s (100) will light as appropriate.
(1) A-bus: ON—*A-bus image fully displayed on the
screen,
blinking—»A-bus image (stronger) and
B-bus image (weaker) on the screen,
blinking—»A-bus image (weaker) and
B-bus image (stronger) on the screen,
ON—»B-bus image fully displayed on the
screen.
Note:
When the Mix/Wipe Lever (99) is positioned at the
center, the brighter part of each respective scene
(between the A-bus signal and B-bus signal) can
be observed on the screen (as opposed to the Mix
function which just mixes the two images).
D-3. Wipe
The wipe pattern is produced from the WIPE PATTERN
block as shown below.
2 .
Notes:
1. The wipe pattern can be generated in combination
with the Wipe Pattern Select Buttons and the
Modify Buttons, Every generated wipe pattern
combination is numbered and is displayed on the
Wipe Pattern Number Indicator (24). Refer to the
Pattern Table on page 28.
2. Each generated wipe pattern can be selected for
the Wipe Edge function and the Wipe Direction
function by appropriately pressing the Wipe Edge
Buttons and the Wipe Direction Buttons.
Wipe Edge
Press the BORDER Button (25) once, a narrow border
is added between the wiped images . If it is pressed
again, the border becomes wide. A third press of the
button eliminaters the border entirely.
Press one of the Matte Color Selectors (13) to select
then add the desired color on the border. (The
complementary color of Matte Color is applied.)
Narrow Border
with Matte Color
Wide Border
with Matte Color
1. Wiping
• Press the WIPE Button (74)
• Select the source signals from the A-bus (102) and the
B-bus (101). In case the MATTE is selected, the color
choice is available from the SELECT buttons (13) on the
MATTE GENERATOR
• Select and press the desired Wipe Pattern Select
Buttons and the Modify Buttons.
• Also if desired, select and press the buttons from the
Wipe Edge Buttons and the Wipe Direction Buttons.
• Operate the Mix/Wipe Lever (99) from A-bus to B-bus,
or vice versa. Wiping is thus performed accordingly.
• Notice that the Mix/Wipe LED's (100) are lighting as
follows.
(1) A-bus; ON—»A-bus image fully displayed on the
screen.
(2) A-bus ; blinking—»The Mix/Wipe Lever (99) moves
to halfway done.
(3) B-bus : blinking—»The Mix/Wipe Lever.(99) moves
after halfway done,
(4) B-bus : ON—»B-bus image on fully displayed the
screen.
Press the SOFT Button (26), A faint border is displayed
between the two video images at the wipe margin. (No
Matte Color is available)
3. Wipe Direction
• Press the ONE-WAY Button (27). The wiping scene
moves the same way every time the Mix/Wipe Lever
(99) is operated.
- 23 -