Mounting in the rack – Panasonic WZ-AD96 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C h a p t e r 4
DB25Y
C
able
To connect the AD converter (TDIF Card installed) with the DA converter
WZ-DA96 and a DTRS device (DA
88 and so forth) you need to build a Y cable
shown below.
MOUNTING IN THE RACK
The AD converter is installed in an EIA 19” rack as follows. .
• Install the AD converter in the rack by using four screws (standard
accessory).
Caution:
• Before mounting make sure that the rack mounting brackets on both
sides the unit are fixed with screws.
• Do not block the ventilation opening or slots on the cover to prevent
the appliance fi-om overheating. Always keep the temperature in the rack
within 45®C (
113*^19.
• Secure the rear of the appliance to the rack by using additional
mounting brackets (procured locally) if the rack is subject to vibrations.
3 1