Panasonic VideoCipher II Integrated Satellite Receiver/Positioner/Descrambler CRD-4500 - Manual (Page 19)

Press I SAT I I W~| (WEST) buttons on remote controller, or press j WEST 1 button
on front panel of the receiver.
The name of the most easterly available Satellite appears automatically.
6 . Satellite
Note: 1. If it is not desired to program that satellite into memory, skip to the next
satellite by pressing I SAT I I W I (WEST).
2. If it is desired to program the satellites in an arbitrary sequence, press I SAT I
I NUMBER BUTTONS I (LETTER) I NUMBER BUTTONS I (NO.) to select
a paticular satellite.
3. When it is desired to program a satellite not listed on table 1, use the system
described in section 10.
Press I W I (WEST) button again.
Search for the most easterly satellite using video scan, or if a known channel is active,
set the receiver to that channel.
7. Skew
When the satellite is recognized adjust the skew using the I < I I >~l buttons on
an even channel.
The word SKEW will be displayed on the screen during the adjustment, SKEW flashes
until the skew limit is reached and the indication stops flashing. Repeat the skew adjust­
ment for an odd channel.
8. Polarizer Control/Format
The CRD-4500 has been pre-programmed with each satellite format (horizontal or
vertical polarization) according to the program guides. If it appears that the format on
any satellite seems to be opposite to the pre-stored information then follow one of the
procedures below:
A) (Preferred) Rotate the feed horn 90 degress without changing the pre-programmed
format. _______
B) Re-program the format for each satellite by using the I H/V I button on the remote
during the setup mode.
9. Memory
Press I ENTER ~| to set antenna position and skew settings into memory.
10. Additional Satellites
To select the next satellite press I SAT 11 W~| (WEST) or enter satellite name directly
I SAT I I NUMBER BUTTONS I (LETTER) I NUMBER BUTTONS I (NO.) and
repeat 6, 7, 8 and 9 steps above.
- 1 8 -