Panasonic RQ-V200 - Manual (Page 11)

■ Live button
(Only for RQ-V200)
This button is used to add gloss to the vocals and
make you feel as if you were hearing a live stage
performance.
When pressing this button, live indicator will ap­
pear. To cancel the live effect, press this button
again. Live indicator will disappear.
This function may not be effective according to the
source.
RADIO
1. Release the hold state.
2. Connect the Included stereo earphones to
the headphones jack.
3. Set the function selector to “RADIO”.
The OPR/BATT indicator will illuminate and the
frequency display will appear.
4. Press the band select button to select the
desired radio band (FM or AM).
5. Press the tuning buttons (“+” or to
tune in your favorite station.
The frequency display will change.
(AM step by 9 kHz, FM step by 0.05 MHz.)
Auto tuning
Hold either of the tuning buttons for more than
0.5 seconds, and then release it. Auto tuning
will operate and stop automatically on next
strong station.
+...TO switch to a higher frequency
-.. .To switch to a lower frequency
When you listen to the FM broadcast, set the
FM mode selector to the proper position.
6. Adjust the volume using the volume con­
trol.
To turn off the radio, set the function selector
to “TAPE/IWI”.
■ FM mode selector
To receive FM stereo broadcasts, set the FM
mode selector to “STEREO". If reception is poor
(excessive noise), set to “MONO". This will re­
duce the noise and provide clear reception, how­
ever, the broadcast will not be heard in stereo.
•When receiving the FM stereo broadcasts, the
stereo indicator will appear.
11