Tape playback, Set the function selector to “tape/[~off, Press the playback button, and playback will begin – Panasonic RQ-V200 User Manual
Page 9: Adjust the volume control, Fast forward and rewind, Auto reverse (continuous playback)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TAPE PLAYBACK
1. Open the cassette compartment cover with
your hand. Insert a cassette, and then close
the cassette compartment cover.
2. Connect the included stereo earphones to
the headphones jack.
3. Set the function selector to “TAPE/[~
of
F|”-
4. Press the playback button, and playback
will begin.
The OPR/BATT indicator will illuminate.
“TAPE” appears on the display for about
5 seconds.
5. Adjust the volume control.
To stop the playback, press the stop button.
Notes:
•Do not open the cassette compartment cover
during playback.
•If you set the function selector to “RADIO"
during playback, the playback button will not
be released although the motor has stopped.
Press the stop button to release the playback
button.
■ Fast forward and rewind
The tape will rapidly advance in the forward or
reverse direction when one of the fast buttons is
pressed.
Notes;
•When the tape reaches the end by pressing
one of the fast buttons, the tape movement
stops, but the unit is not turned off. Do not
leave the set in this condition. Be sure to
press the stop button.
•Do not press the playback button during fast
forward or rewind, as this may jam the tape.
Between functions, always press the stop
button first.
■ Auto reverse (Continuous playback)
When the tape comes to an end, the tape direc
tion changes automatically to start playing the
opposite side of the tape.
•The cassette tape will run continuously, chang
ing from forward to reverse, then back again,
etc., until the stop button is pressed.