Software preparation (first time only), Using the dvd-rom drive pack in the ms-dos mode, Software preparation – Panasonic DVD-ROM Drive Pack CF-VDD712 User Manual
Page 8: First time only), Éntet)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Software Preparation
(first time only)
The following settings are necessary to prepare the DVD-ROM Drive Pack for use:
(t
:The following settings are unnecessary.)
1
Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System]
- [Device Manager] - [CD-ROM] - [MATSHITA DVD-ROM SR-8173] - [Set
tings].
2
Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive
letters].
3
At the [System Properties], click [ok]. The display will ask you to restart Win
dows, then press [Yes].
X
note
)-------------------------------------------------------------------------------------------------------
ftWindS95l»
(with the FIRSTAID CD included):
When reinstalling, refer to the above steps 2 - 3 to set the reserved drive letters of the CD-ROM drive.
<The
model that
the CD-ROM
Pack
(CF-VCD711) is
not included>
When booting up from the FIRSTAID FD (for example, to reinstall the operating system), the
DVD-ROM Drive does not have to be replaced by the CD-ROM Drive (CF-VCD711). The
CD-ROM driver will recognize the DVD-ROM Drive.
Using the DVD-ROM Drive Pack in the MS-DOS mode
: It is unnecessary to read this explanation.)
To use the DVD-ROM Drive Pack in the MS-DOS mode, configure the drive following the
steps below after performing the above steps I - 3. If the steps listed below are per
formed without completing steps 1-3 above first, the drive will not operate properly.
1
Click the [Start] button then select [Shut Down],
2
Select [Restart in MS-DOS mode] and click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd\C
ÉnteT)
edit config.sys C
Enter
J
4
Move the cursor to the line containing "SHEBD ATAPICD.SYS*" and
delete the characters "rem" at the beginning of the line. (Deleting "rem" causes
the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\ATAPICD.SYS*/D:MSCDOOO
(If this line is missing, add it.)
+ATAPICD.SYS ^
: OAKCDROM.SYS