Panasonic DVD-ROM Drive Pack CF-VDD712 - Manual (Page 9)

5
Press
(
Alt
] +CED
.then
CD
to save the file. Then press
C Alt
) + CD
. then
(
X
)
to
exit the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file,
edit autoexec.bat i Enter )
7 Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WlNDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
3
Press
(
Alt
)
+
CE)
. then
CD
to save the file. Then press
C
Alt
)
+
CE)
. then CID to
exit the Edit program.
9
Restart the computer.
Power-saving mode
If the DVD-ROM Drive Pack has not been accessed within 120 seconds, the drive motor
will automatically shut down to reduce the power consumption. When the DVD-ROM
Drive Pack is accessed once again, the power of the drive motor is turned on. However,
approximately 30 seconds are required until data is actually read from the disc.
note )-
#[3'^ Floppy (A:)] displayed in [My Computer] can be selected, when you use the
floppy disk drive as an external device (c^ page 6)
•References to the "CD-ROM" in the Setup Utility will not change to "DVD-ROM",
even when the DVD-ROM Drive Pack is installed.
• If the vibration of the DVD-ROM drive is excessive, set the CD-ROM Drive Speed
to [12x speed] (or displayed [Low] ) in the Setup Utility. ( The display of the item
may remain unchanged when the DVD-ROM Drive Pack is installed. )