Panasonic RQ-L50 - Manual (Page 5)

REC
To record with VAS (Voice Activated System) function
ш
RQ-L 30 ~| only)
The sound is recorded automatically,
so there is no tape waste.
To use VAS function, set the [VAS]
selector to “1" or “2" in step ©.
1: If you wish to record lower levels of
sound than usual.
2: If you wish to record only the louder
sounds.
Note:
After using VAS function, set the
[VAS] selector to “OFF"
To record through the externai microphone
(IÎQ51 rRQ-L30 I only)
Plug the external microphone (not in­
cluded) into the [MIC] jack.
•You can use a condenser micro­
phone with or without built-in power
supply.
► Plug type: 3.5 mm in.) monaural
Monitoring
The sound can be heard with an op­
tional earphone plugged into the
[EARPHONE] jack.
• Plug type: 3.5 mm (V^ in.) monaural
Note:
•You can not adjust the volume during
recording.
Record prevention
Removing the tab(s) of the cassette
(with a small screwdriver) will prevent
accidental erasure.
To record again, cover the hole of the
tab with adhesive tape.
Adhesive tape
PLAYBACK
Cue and review
Sound can be monitored at a high
speed as long as the [FF/CUE] (cue)
or [REW/REVJ (review) is held down
during playback.
When the button is released, normal
playback will start.
ВАТТ
•Align the poles (© and ©) properly
when inserting the batteries.
•Do not mix old and new batteries or
different types of batteries.
• Do not recharge ordinary dry cell bat­
teries.
• Remove the batteries if the unit is not
to be used for a long time.
Mishandling of batteries can cause
electrolyte leakage which can damage
items the fluid contacts and may cause
a fire.
If electrolyte leaks from the batteries,
consult your dealer. Wash throughly
with water if electrolyte comes in con­
tact with any part of your body.
(I RQ-L30 I ll:I*MmOI Only)
•If rechargeable batteries are to be
used, rechargeable batteries manu­
factured by Panasonic are recom­
mended.
Battery level indicators
The [ВАТТ LEVEL] indicators light
during operation. As the charge re-
duces the lamps go out.
When the battens are weak
The indicator under “E" becomes dim
or turns off.