Panasonic OMNIVISION PV-HD1000 - Manual (Page 12)

One Time D-VHS VCR Setup
(continued)
^Important: !f the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
When the D-VHS VCR is turned on for the
first time, it automatically enters the setup
mode.
Setup includes the following:
• Tell the D-VHS VCR how your equipment is
hooked up (pages 6~1 1 ) so the D-VHS VCR
can correctly place channels into memory.
• Get the D-VHS VCR ready for clock set.
10-11
Back of
D-VHS VCR
ACTION -
O © ©
© © ©
O ® ©
© © ©
O CD O l
O
e
Q ©I
VOL — ^
O Qi
10
ft
11
Using ► keys
When a MENU or PROGRAM ^
screen is displayed, the Pl_AY, STOP,
REWIND, and FF buttons on the remote
control function as AT-^ ► only.
A.
O'
To Set the Cable/DSS Receiver,
Channels and Auto Clock Set
1
Turn the TV and D-VHS VCR on.*
Tune your TV to the D-VHS VCR output channel
(the same one you set on the back of the D-VHS VCR; CH3 or
CH4).
• If you used audio/video jack connection, tune the TV to its video input.
Press AT to select your connection
type, and then press ► to set.
• If you use a cable box or DSS receiver
and selected “YES”, go to step 4.
• If you selected “NO”, “CABLE BOX
CONTROL IS NOT AVAILABLE” is
displayed. Go to “Alternate Instructions”
on page 14.
ARE YOU USING A CABLE
BOX OR DSS RECEIVER?
NO
SELECT;* ▼ KEY
SET :> KEY
END lACTtON KEY
Press AT to select your hookup,
and then press to set.
• If you selected “CABLE/DSS BOX ►VCR
►TV,” continue with step 5. If not, go to
“Alternate Instructions” on page 14.
• If you are using the CABLE/DSS BOX^
VCR^TV connection method, only the
cable box output channel will be placed in memory.
SELECT HOOKUP
CABLE/D5S BOX^VCR^TV
VL.K*CABLE/DSS BuX*rv
SELECT:* ▼ KEY
SET : *. KEY
END :ACT I ON KEY
Press AT to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If both a cable box and DSS receiver are used,
set the output channel of the DSS receiver,
• If you are using Audio/Video jack
connections to your cable box, select and
set “VIDEO OUT as the output channel.
SELECT HOOKUP
CABLE/DSS BOX*VCR*TV
CABLE/DSS BOX OUTPUT CH
SELECT
SET
END
* ▼ KEY
► KEY
ACTION KEY
Press AT to select your cable
box or DSS receiver code number,
and then press 1^ to enter.
(Refer to the list on page 11.)
• If your cable box or DSS receiver
doesn't have a remote control,
select “NO REMOTE.” Then, go to
Alternate Instructions on page 14.
• This determines whether the D-VHS VCR will
control your cable box or DSS receiver.
ENTER CODE NUMBER
referring to manual
SELECT:* ▼ KEY
SET :► KEY
END
:ACT I ON KEY
12
Continued on the next page.