Panasonic DMC-TZ2 - Manual (Page 46)

Camera may become warm if used for long periods of time, but this is not a fault.
■ To avoid jitter, use a tripod and piace in a stable location.
{Especially when using telescopic zoom, lower shutter speeds, or self-timer)
Keep the camera as far away as possible from electromagnetic equipment (such
as microwave ovens, TVs, video games etc.).
»if you use the camera on top of or near a TV, the pictures and sound on the camera
may be disrupted by electromagnetic wave radiation.
»Do not use the camera near cell phones because doing so may result in noise
adversely affecting the pictures and sound.
»Recorded data may be damaged, or pictures may be distorted, by strong magnetic
fields created by speakers or large motors.
»Electromagnetic wave radiation generated by microprocessors may adversely affect
the camera, disturbing the pictures and sound.
• if the camera is adversely affected by electromagnetic equipment and stops
functioning properly, turn the camera off and remove the battery or disconnect AC
adaptor (DIVIW-AC5PP; optional). Then reinsert the battery or reconnect AC adaptor
and turn the camera on.
Do not use the camera near radio transmitters or high-voltage lines.
• If you record near radio transmitters or high-voltage lines, the recorded pictures and
sound may be adversely affected.
#Do not extend the supplied cord or cable.
• Do not allow camera to come into contact with pesticides or volatile substances (can
cause surface damage or coating to peel).
• Only use files from other devices if compatible with Design Rule for Camera File
system (Pictures are based on DCF (Design rule for Camera File system) and Exit
(Exchangeable Image File Format) standards, by Japan Electronics and Information
Technology Industries Association (JEITA)}.
Cannq lui
• Disconnect battery/AC adaptor (DMW-AC5PP, sold separately).
• Do not use benzene, thinners, alcohol, kitchen detergent, or chemically treated cloth
(can cause surface damage or coating to peel).
'»Wipe away dust or fingerprints with soft, dry cloth. Clear stubborn stains or rain/sea
water stains with a thoroughly wrung cloth, before wiping with a dry cloth.
• Remove battery and card (ensure that battery is removed to prevent damage through
over-discharge).
• Do not leave in contact with rubber or plastic bags.
• Store together with a drying agent (silica gel) if leaving in drawer, etc. Store batteries
in cool (15 “C-25 °C (59 “F-77 °F)) places with low humidity (40 %-60 %) and no
major temperature changes.
• Charge battery once per year and use completely once before storing again.
•To prevent damage to cards and data
«Avoid high temperatures, direct sunlight, electromagnetic waves, and static
electricity.
*Do not bend, drop, or expose to strong impacts.
®Do not touch connectors on reverse of card or allow them to become dirty or wet.
#When disposing of/transferring memory cards
«If using the ‘format’ or ‘delete’ functions on your camera or computer, this only
changed the file management information, and does not completely delete the data
from Within the memory card. When disposing of or transferring your memory cards,
we recommend physically destroying the memory card itself, or using commercially
available computer data erasing software to completely delete the data from the
card. Data within memory cards should be managed responsibly.
■
B.ittery
■ Store battery in battery carrying case after use.
■ 'Do not use if damaged or dented (especially connectors),
e.g. by dropping (can cause faults).
■ The unusable battery should be discarded in accordance
with battery recycling laws. Call the RBRC hotline at 1-800­
822-8837 for information.
^Estimated recording capacity of 270 [300* • ’] pictures (P.14)
is based on the following CIPA'^^ standards.
DMC-TZ2
CIPA standards:
«Using Panasonic SD memory card (16MB) «Temperature 23 ‘’C (73.4 °F), humidity
50 % »NORMAL PICTURE mode ®LCD monitor ON «STABIUZER (MODE1) -«First
picture taken 30 sec after power turned on *1 picture taken per 30 sec eFull flash
used for every other picture »Zoom operation for each picture (max. W ^ max. T, or
max. T > max. W) «Power turned off after each 10 pictures, battery allowed to cool
CIPA= Camera & Imaging Products Association
•When charging
«Remove any dirt on connectors with dry cloth.
«Keep at least 1 m (3.28 feet) away from AM radio (may cause radio interference).
«Noises may be emitted from inside, but this is not a fault.
»Always remove from mains socket after charging (up to 0.1 W consumed if left in
place).
• SDHC Logo is a trademark.
® Leica is a registered trademark of Leica Microsystems IR GmbH.
• Elmar is a registered trademark of Leica Camera AG.
• Other names, company names, and product names printed in these instructions
are trademarks or registered trademarks of the companies concerned.
90
VQT1B61 VQT1B61
91