Ting battery and card, Approximate battery life number of pictures, Inserting battery and card – Panasonic DMC-TZ2 User Manual
Page 8: Ipsya«,«::/:;;:: charging, Battery
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ipsya«,«::/:;;:: Charging
battery
. .
■ Rrèparaiions:- (:■.■ ‘ ■ v
Always charge before first use!
(not sold pre-charged)
ting battery and card
Battery (model-specific)
Charger
(node'-specific)
ir“
ndoor electrical outlet
{charge at room temperature of 10-
35°C (50°F-95“F))
Kt-
Mp I
2
Fold
out pins and
plug
into electrical outlet.
Disconnect
charger
and
battery when charging is
compiete.
©Connect to charger.
(Ensure ‘LUIVIIX’ faces outwards.)
plug
'Charging light (CHARGE)
'
• On:
Charging in progress (approx. 120 min.)
#Off: Charging compiete
• If light is flashing...
»Battery temperature is too high/too low ^ Battery may still be charged, but it will
take longer as it must adjust to the room temperature.
•Battery/charger connector is dirty ^ clean with dry cloth.
■Approximate
battery life
Number of pictures:
270 [300*2]
(g( 30-sec intervals) (equivalent to approx. 135 [150
*2]
mins)
* ' Values based on Cl PA standards. (P91)
(Number reduced if intervals longer - 67 [75 *2] pictures if 2-minute intervals)
Playback time: Approx.
260 [280 *2]
mins
Above figures may be reduced if intervals between recording are longer; if flash, zoom,
or POWER LCD are used frequently; or in colder climates (depends on actual usage).
*2 DMC-TZ2
( Note )
©Battery will be warm during charging and for some time thereafter.
©Battery will run out if not used for long periods of time, even after being charged.
• Battery can be topped up even if not fully depleted.
• Do not disassemble or modify the charger.
• Please purchase a new battery if battery life becomes significantly reduced.
' Battery
(check orientation)
Card
(check orientation)
Do not touch
connector
©Set the
camera
ON/OFF
switch
to
OFF
©Slide
to the ‘OPEN’ position and
open the lid
©Completely insert battery and card
(both click into place)
©Close lid
* Slide to the ‘LOCK’ position.
OPEN
.OCK
/ V r
ITo remove
•To
remove battery,
move lever in direction
of arrow.
«To remove card,
press down in center.
■Compatible memory cards
(sold separately)
• The following SD standard-based cards (Panasonic brand
recommended)
*SD memory cards, 8MB-2GB
*SDHC memory cards (4GB) ^ (P.96)
(4GB (or greater) cards without the SDHC logo are not of SD standard.)
— For recording picture/time capacity, see (P.92)
— For model numbers and types,
(This Site is English only.)
• MultiMediaCards (still images only)
SDHC logo
( Caution )
SDHC
memory
card
«Always use genuine Panasonic batteries.
• If you use other batteries, we cannot guarantee the quality of this product.
#Do not remove card or battery while power is ‘ON’ or while status indicator is on
(Camera may cease operating correctly, or card/recorded contents may be damaged).
• The reading/writing speed of a MultlMediaCard is slower than an SD memory card. When a
MultiMediaCard is used, the performance of certain features may be slightly slower than advertised.
• Keep the Memory Card out of reach of children to prevent swallowing.
14
VQT1B61
VQT1B61
15