Panasonic KXL-783M - Manual (Page 33)

Trouble Possible Cause Solution
CD-ROM Tool Kit icon
does not appear when
starting Macintosh.
CD-ROM ToolKit has not
been loaded properly.
Reinstall the software
{(@r P. 12-15).
CD-ROM ToolKit is
not loaded properly.
(When starting
Macintosh, following
icon appears.)
CD-ROM driver other
than CD-ROM ToolKit is
being used.
Remove the CD-ROM driver other
than CD-ROM ToolKit from System
Folder and restart your Macintosh.
Your Macintosh does
not recognize the
player (When
starting Macintosh,
following icon
appears), or does
not function properly.
Your Macintosh is not
setup correctly.
Install the software by using the
supplied Setup disk (osr P. 12—15).
Macintosh is turned on
before turning on the
player. Turn on the player, then turn on
your Macintosh.
The SCSI cable is not
connected to the player
or to Macintosh properly.
Properly connect the SCSI cable
(ET P. 10, 11).
The SCSI cable pin is
bent or broken.
I When using with PowerBook;
Contact your dealer (or contact
Panasonic Service Center at
1-800-PANA-SYS for users in
continental United States).
I When using with Desktop Macintosh:
Contact the store which you
purchased the SCSI cable.
There are duplicate
SCSI ID numbers for
devices in your system.
Set a different SCSI ID number for
each device in your system
(ET
P. 37).
The player’s terminator
is set to OFF.
Set the terminator to ON
(E^ P. 37).
Check the box next to the
player’s SCSI ID number on
CD-ROM ToolKit Control
Panel is not on.
Open the CD-ROM ToolKit Control
Panel and check the box next to the
SCSI ID number of the player
(0^ P. 26).
CT
(D
W
S’
o
o
5‘
(O
33