Windy Nation P30L LCD 30A Solar Charge Controller - Manual (Page 10)

P30L User Manual
Revision 1.0
LOAD ON
By pressing the ‘DOWN / LOAD’ button from this interface, you can turn the load ON or OFF.
NOTE: The Load on/off function is not available in any other interface.
3.4.2 Battery Temperature Interface
The value displayed in this interface is the temperature at the Battery Temperature Sensor (BTS) as
described in Section 2.3 (displayed in degrees Celsius). The temperature is used for the temperature
compensation of battery charging.
3.4.3 PV – Solar Panel Output Current Interface
The value displayed in this interface is the input current to the controller from the solar panels; i.e.: the
current being generated by the solar panels (displayed in Amps).
3.4.4 Load Current Interface
The value displayed in this interface is the output current from the controller to the load; i.e.: the current
being consumed by the load (displayed in Amps).
3.4.5 PV – Solar Panel Generated Charge Interface
The value displayed in this interface is the cumulative, generated charge of the solar panels displayed in
Amp-hours (Ah). For example, if 5 amps is supplied to the battery from the solar panel(s) for 1 hour, then 5
Ah will be displayed on the LCD.
Battery Voltage
BTS Temperature
PV Current
Load Current
Page 10 of 16 windy nation 01/20/2014