360 Systems MAXX-2420EX - Manual (Page 40)

Page 40 MAXX-2420-EX Owner’s Manual
Setting the Audio Input Source
Select OPTIONS >CONFIGURE from the Channel 1 Transport Window. The Dialog box in
Figure 9 appears.
• Select an Audio Input by clicking the desired button.
• Click APPLY or OK.
Embedded audio is eight tracks contained in the HD-SDI video stream.
AES/EBU Digital Audio refers to audio input from the optional DXP-1 multi-channel module.
Analog Audio refers to audio input from the optional AXP-3 and AXP-4 multi-channel module.
Arming Audio Tracks
• Select OPTIONS >CONFIGURE from the Channel 1 Transport Window. Refer again to
Figure 9 - Channel Configuration Dialog.
• Under TRACK ARM, check the AUDIO box if recording audio is desired. All eight tracks are
recorded.
• Click APPLY or OK
Setting an Audio Delay Time
Audio tracks can be offset from video in 1 millisecond increments up to +/- one second. The
setting is per channel and non-volatile. It applies to playback only, not recording.
You must stop and start the playback to hear the result of a change. This adjustment is made in
Transport mode; once set it also applies to Playlist mode on that channel.
• Select OPTIONS >CONFIGURE from the Channel Transport Window. The Dialog box in 10
appears.
• Click the OUTPUT tab.
• Enter a time offset value in the window.
• Click APPLY or OK.