360 Systems MAXX-2420EX - Manual (Page 53)

MAXX-2420-EX Owner’s Manual Page 53
Programming GPI Inputs
The MAXX-2420-EX has 12 General Purpose Inputs, referred to as GPI 1 through GPI 12. Each can
be programmed to trigger one of the following events on a channel:
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Immediately plays next cued clip in a playlist for playback (Playlist
Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPI Input, select EDIT >CONFIGURE >GPI. The screen of Figure 16 will be
displayed. GPI 1 through 12 are programmable inputs. The checkboxes to the right of each selection
represent video channels 1, 2, 3 and 4. GPI 9 is shown with an expanded pulldown for trigger
option.
1. To activate a GPI input, select the event from the pulldown the event menu
2. Mark a checkbox for the channel of interest. The event will be triggered when that GPI goes
active.
3. Click APPLY to activate.