Programming gpio outputs – 360 Systems Image Server 2000 User Manual

Page 46

Advertising
background image

Page 46

Image Server 2000 Owner’s Manual

Programming GPIO Outputs

The Image Server has six General Purpose Outputs, referred to as GPO 1 through GPO 6. Each GPO
can be programmed to go active on the selected channel when one of the following events occurs.

IDLE

- Activate when the transport returns to idle

PAUSED

- Activate when the transport is paused

STOPPED

- Activate when the transport is stopped

PLAYING

- Activate when the transport is playing

RECORDING

- Activate when the transport is recording

RAID System Fault

- Activate when a RAID or System Fault occurs

NO GENLOCK

- Activate when there is no genlock

NO VIDEO INPUT

- Activate when there is no video at the selected input

PLAYLIST

- Control GPO via playlist. (Refer to page 63.)

To program a GPIO output, select EDIT->CONFIGURE->GPO. The screen of Figure 11 is
displayed. GPO 1 through 6 are the 6 triggerable outputs. The checkboxes to the right of each
selection represent channel 1, 2 and 3. GPO 5 is shown with the trigger option pulldown expanded.

To activate one of the GPO, pulldown the event menu and select which event will activate the GPO.
Select an associated channel where applicable by checking the channel checkbox. Click APPLY to
activate.

Figure 11 - GPO Configuration Screen

Advertising