360 Systems Image Server 2000 - Manual (Page 48)

Page 48 Image Server 2000 Owner’s Manual
Configuring Linear Time Code (LTC)
The Image Server supports only drop-frame time code for NTSC operations. It may not be used with
non-drop-frame time code. LTC Out Source chooses which channel will control the LTC Timecode
output.
Configuring the Network
The Image Server provides a number of user settings that configure it for use as a practical network.
These will be found on the Configure Network tab shown below.
The NET-1 Ethernet port on the Image Server has a unique IP Address. In this way, each Image
Server can be identified on the network.
Network Settings Tab
Use the Image Server graphic user interface to configure network communication settings. From
the Main Menu selection bar at the top of the screen.
Click EDIT>CONFIGURE->NETWORK
The screen of Figure 13 is displayed.
Figure 13 - Network Configuration Screen