360 Systems Image Server 2000 - Manual (Page 98)

Page 98 Image Server 2000 Owner’s Manual
Gigabit Ethernet Indicators
The Gigabit Server Adapter card has the following indicator lights:
Label Indication Meaning
Green on The port is connected to a valid link partner
Green flashing Data activity
ACT/LNK
(Left)
Off No link
Off 10 MBps
Green 100 MBps
10=OFF
100=GREEN
1000=YELLOW
(Right)
Yellow 1000 MBps
Access to Components
Be certain to shut down the Image Server, turn off the rear panel power
switch and disconnect the power cord before opening the unit for service.
The following sections provide instruction on disassembly and re-assembly for maintenance.
The front panel is removed to access the internal CD-ROM drive (for system program updates), or
to service the hard drives.
The top cover is removed to access the analog/digital audio selection jumpers, or to service an I/O
card, the system board, or power supply.
Removing the Front Panel
The front panel is easily removed for access to the CD-ROM drive, the four disk drives, or for
removing the server from an equipment rack. Using a coin or a flat-blade screwdriver, unscrew
the two large panel fasteners on the left and right sides of the face panel. Hold the panel in
place while undoing the screws. Since the loosened screws are captive, you may use them to
pull the panel away from the chassis.
To re-install the front panel, tuck all wires into the chassis and move the face panel into
position. Screw the front panel fasteners back into the chassis. Tighten the front panel access
screws with a screwdriver.
Removing the Top Cover
Using a No. 2 Philips head screwdriver, unscrew the three 6-32 Philips head screws attaching
the top cover to the rear panel. Slide the cover back until it is clear of the front panel, and then
lift it off.