360 Systems Image Server 2000 - Manual (Page 47)

Image Server 2000 Owner’s Manual Page 47
Programming GPIO Inputs
The Image Server has six General Purpose Inputs, referred to as GPI 1 through GPI 6. Each GPI can
be programmed to trigger one of the following events on a channel.
CUE Cue a clip
JUMP Cue selected clip for immediate playback (Playlist Mode only)
NEXT Prepare next clip in a playlist for playback (Playlist Mode only)
PAUSE Pause a clip
PLAY Play a clip
RECORD Start a recording
SELPREV In Playlist Mode – Navigate to clip above currently selected clip
SELNEXT In Playlist Mode – Navigate to clip below currently selected clip
STOP Stop a clip
To program a GPIO Input, select EDIT->CONFIGURE->GPI. The screen of Figure 12 is displayed.
GPI 1 through 6 are the 6 programmable inputs. The checkboxes to the right of each selection
represent channel 1, 2 and 3. GPI 5 is shown with the trigger option pulldown expanded.
To activate one of the GPI, check the checkbox for the channels of interest, then pulldown the event
menu and select which event will be triggered when the GPI goes active. Click APPLY to activate.
Figure 12 - GPI Configuration Screen