Acoustica Mixcraft 7 - Manual (Page 80)

74
SOUND TAB – AUDIO SUB TAB
Here you’ll find some useful extra parameters.
 Channels
If the audio clip is stereo, the pop-up menu selects regular stereo playback or left
or right channel only. If left or right channel is selected, playback becomes mono
and the channel pan slider will control panning. (If a clip is playing in stereo, the
pan slider acts as a balance control.)
 Phase
Normal plays in standard stereo; Invert Left, Invert Right, and Invert Both flips the
waveform phase 180 degrees of each respectively.
 Noise Reduction
Mixcraft features built-in noise reduction feature for audio clips. Noise may be
background hum, clicks and pops, or any other unwanted sound (not including
your band’s drummer). However, Mixcraft’s noise reduction works best on
steady-state noise such as fans, air conditioners, or anything constant throughout
the recording.
To use Mixcraft’s noise reduction, highlight the audio clip you’d like to remove the
noise from, then click the Sound tab on the bottom. Now click the Noise Reduction
button next to the slider, and select a value up to 100%. Once an amount is
selected, Mixcraft will attempt to locate good noise sample. Mixcraft shows the
noise section by two controls called Noise Start and Noise End.