Checkline TI-CMXDL - Manual (Page 2)

1.0 I NTRODUCTION
The Electromatic TI-CMXDL is an ultrasonic thickness gauge that measures with extreme
versatility. It has the ability to simultaneously measure coatings and material thicknesses while
maintaining the ability to locate pits, flaws and defects in the material. Based on the same
operating principles as SONAR, the TI-CMXDL is capable of measuring the thickness of various
materials with accuracy as high as ± 0.001 inches, or ± 0.01 millimeters. The principle advantage
of ultrasonic measurement over traditional methods is that ultrasonic measurements can be
performed with access to only one side of the material being measured.
NOTE: Inherent in ultrasonic thickness measurement is the possibility that the instrument will
use the second rather than the first echo from the back surface of the material being
measured. This may result in a thickness reading that is TWICE what it should be.
Responsibility for proper use of the instrument and recognition of this phenomenon rest
solely with the user of the instrument. Other errors may occur from measuring coated
materials where the coating is insufficiently bonded to the material surface. Irregular
and inaccurate readings may result. Again, the user is responsible for proper use and
interpretation of the measurements acquired.
1.1 Overview
-2-
Probe
Keypad
Aluminum
Housing
LCD Backlit
Display
LED Alarm
Indicators
Probe
Receptacles
Probe Zero Plate
& Battery Cover
(3x AAA alkaline
batteries installed)
-67-
W ARRANTY
ELECTROMATIC Equipment Co., Inc. (ELECTROMATIC) warrants to the
original purchaser that this product is of merchantable quality and confirms
in kind and quality with the descriptions and specifications thereof. Product
failure or malfunction arising out of any defect in workmanship or material in the
product existing at the time of delivery thereof which manifests itself within one
year from the sale of such product, shall be remedied by repair or replacement of
such product, at ELECTROMATIC’s option, except where unauthorized repair,
disassembly, tampering, abuse or misapplication has taken place, as determined by
ELECTROMATIC. All returns for warranty or non-warranty repairs and/or replace-
ment must be authorized by ELECTROMATIC, in advance, with all repacking and
shipping expenses to the address below to be borne by the purchaser.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOTLIMITED TO, THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULA
PURPOSE OR APPLICATION. ELECTROMATIC SHALL NOT BE RESPONSIB
NOR LIABLE FOR ANY CONSEQUENTIAL DAMAGE, OF ANY KIND OR
NATURE, RESULTING FROM THE USE OF SUPPLIED EQUIPMENT, WHETH
SUCH DAMAGE OCCURS OR IS DISCOVERED BEFORE, UPON OR AFTER
REPLACEMENT OR REPAIR, AND WHETHER OR NOT SUCH DAMAGE IS
CAUSED BY MANUFACTURER’S OR SUPPLIER’S NEGLIGENCE WITHIN
ONE YEAR FROM INVOICE DATE.
Some State jurisdictions or States do not allow the exclusion or limitation of inciden
or consequential damages, so the above limitation may not apply to you. The duratio
of any implied warranty, including, without limitation, fitness for any particular
purpose and merchantability with respect to this product, is limited to the duration
of the foregoing warranty. Some states do not allow limitations on how long an
implied warranty lasts but, not withstanding, this warranty, in the absence of such
limitations, shall extend for one year from the date of invoice.
ELECTROMATIC Equipment Co., Inc.
600 Oakland Ave. Cedarhurst, NY 11516—USA
Tel: 1-800-645-4330/ Tel: 516-295-4300/ Fax: 516-295-4399
Every precaution has been taken in the preparation of this manual. Electromatic Equipment Co., Inc., assum
no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use
information contained herein. Any brand or product names mentioned herein are used for identification purp
es only, and are trademarks or registered trademarks of their respective holders.