Cub Cadet SLTX1000 Series - Manual (Page 115)

CVT DRIVE AND BRAKE SYSTEM
109
Belt control: tension make-up pulley
1. Remove the upper drive belt from the make-up ten-
sioner pulley as described in the drive belts section of
this chapter. See Figure 6.37.
2. Unbolt the arm from the torque bracket using a pair of
9/16” wrenches. See Figure 6.38.
! CAUTION ! CAUTION
The battery will be removed in this procedure. Review the Operator’s Manual and Chapter 7:
Electrical System for important safety information about handling batteries before proceeding.
Figure 6.37
Bolt loosened
Figure 6.38
Tension make-up
arm pivot bolt