Cub Cadet SLTX1000 Series - Manual (Page 47)

Body Panels
41
Seat and Fenders
There are four variants of fender used on the Cub Cadet Series 1000 for the model year 2009 and after:
• Manual PTO models have two levers on the right fender: one for the deck height control and one for the
PTO.
• Electric PTO models have one lever on the right fender to control the deck height.
• CVT-drive tractors (single-speed transmission + variable speed pulleys) use fenders with a single pedal
opening on each side: clutch/brake on the left, drive pedal on the right. In addition, a forward-neutral-
reverse lever is on the left fender.
• Hydrostatic-drive tractors use fenders with a single pedal opening on the left, and two openings on the
right. The clutch/brake pedal is on the left, with two pedals on the right; one to control forward drive, and
the other to control reverse drive.
NOTE: Removing the fenders provides access to:
• The bolts that hold the base of the dash panel to
the frame. See Figure 4.13.
• The nut that holds the drive belt tensioner pivot
bracket to the frame.
• The travel stop pin that must be taken-off to
remove the control pedal cross-shaft.
! CAUTION ! CAUTION
The battery will be removed in this procedure. Review the Operator’s Manual and the Chapter
7: Electrical Systems for important safety information about handling batteries before pro-
ceeding.
IMPORTANT: Do not return an unsafe mower to service.
Figure 4.13
Drive belt tensioner
bracket pivot bolt
Dash
mounting
bolts