Cub Cadet SLTX1000 Series - Manual (Page 46)

LTX Tractors
40
Hood components: pivot bracket removal
1. Remove the four screws that hold the outer arms of
the pivot bracket to the hood using a 3/8” wrench.
See Figure 4.11.
2. Remove the two screws that hold the pivot bracket
and grill to the hood assembly using a 1/2” wrench.
See Figure 4.12.
3. Assemble and install the grill by reversing the steps
used to remove it.
• Tighten the small screws to a torque of 15-35
in-lbs. (1.7-4.0 N-m).
• Tighten the large screws to a torque of 25-45
in-lbs (2.80-5.1 N-m).
Figure 4.11
pivot bracket
Small
screws
Small
screws
Figure 4.12
Pivot bracket
Large Screws
Hood
Grill